SSA5000A Firmware Update
バージョン
V1.9.0.2.2R3
2025-05-27
バージョンの説明
New Functionality:
- Add user calibration for reference clock
- SA mode: optimize refresh efficiency
- AMA mode: optimize AF smoothing effect
- NF mode: exporting table results as .csv files
- Add FTP switch function
- SA mode: align estimated scan time and regular scan time
- BT mode: solve issues including Preset, EDR signal demodulation, and no response to quick operations
- PN mode: solve issues including signal averaging failure and incorrect sweep width
- NF mode: solve issues including calculation errors
- RTSA mode: solve issues including no waveform in screenshots, peak failure, failure to save and load files, and missing reference offset
- Add and modify SCPI commands:
1. Period cursor reading error (:CALCulate:MARKer:FCOunt:X?)
2. Query cursor function returns off (CALCulate:MARKer:FUNCtion?)
3. Setting external trigger command is inconsistent with programming manual (:TRIGger[:SEQuence]:SOURce)
4. Harmonic analysis command is missing to obtain each order harmonic frequency and power and obtain total harmonic distortion
(:READ:HARMonics:AMPLitude:ALL? :READ:HARMonics:DISTortion?)
5. SA command reads back cent, low, high.Q results when obtaining NDB results(:CALCulate:MARKer:BANDwidth:RESult?)
2. Query cursor function returns off (CALCulate:MARKer:FUNCtion?)
3. Setting external trigger command is inconsistent with programming manual (:TRIGger[:SEQuence]:SOURce)
4. Harmonic analysis command is missing to obtain each order harmonic frequency and power and obtain total harmonic distortion
(:READ:HARMonics:AMPLitude:ALL? :READ:HARMonics:DISTortion?)
5. SA command reads back cent, low, high.Q results when obtaining NDB results(:CALCulate:MARKer:BANDwidth:RESult?)
SSA5000A Firmware Update
バージョン
V.1.1.2.2.0
2024-03-12
バージョンの説明
New Functionality:
- Add Phase Noise Measurement Mode
- Add Noise Figure Measurement Mode
- Add Pulse Measurement Mode
- Add Blue Tooth Analysis Mode
- Add AF spectrogram, SNR,Dist/Total,THD parameter analysis results in AMA Mode
- Add image browsing in SYSTEM
- EMI mode Scan Only rescan with one less count issue
- EMI mode sending command unable to rescan meter and Meas issues
SSA5000A Firmware Update
バージョン
1.1.2.1.7R3
2023-08-29
バージョンの説明
Improvements:
• Support EMI mode
• VNC interface optimization
Solved Issues:
• The default detection type of the third-order intermodulation in SA mode is changed to Pos
• Fixed cursor readout update error when the readout type is not auto
• 10db higher signal amplitude under harmonic analysis
• Harmonic analysis cannot modify the number of harmonics
• Solved the problem that FTP cannot be used
• MA mode time domain graph marker display unit corrected to dBV
• Support EMI mode
• VNC interface optimization
Solved Issues:
• The default detection type of the third-order intermodulation in SA mode is changed to Pos
• Fixed cursor readout update error when the readout type is not auto
• 10db higher signal amplitude under harmonic analysis
• Harmonic analysis cannot modify the number of harmonics
• Solved the problem that FTP cannot be used
• MA mode time domain graph marker display unit corrected to dBV
バージョンの説明
バージョンの説明
